CASE STUDY
SymSizer size press uneven nip loading
A SymSizer was having intermittent problems with sheet breaks when the rolls were nipped up. As the rolls touched, the sheet would steer to one side, wrinkle badly, and then break. The problem did not occur every time, so it was difficult to troubleshoot.
|
|
CASE STUDY
Sizer applicator beam not unloading at sheet break
A mill was having issues with the top roll applicator beam on their SymSizer not opening on sheet breaks. It became a safety issue, as long handled crowbars were needed to assist the beam to open. This was also a risky situation for the health of the applicator beam if the roll were to wrap during a sheet break.
|
|
CASE STUDY
Size press roll wear causes reel wrinkles and culls
A printing & writing paper machine experienced excessive wear on the bottom size press roll on the back edge. This caused excess starch to be applied to the sheet, sometimes causing the paper to wrinkle at the reel and be culled.
|
|
|
|
Manage your profile to opt-out, ExampleEMarketingManageProfileLink for specific Valmet subscriptions.
Addresses: Valmet customer data
|
Contact us | Follow us on |
www.valmet.com/na |